×

Desk PC 2.0 Update: New Cable Chain Design finished

In

While installing all the wires and cables I decided to give the initial version of my drag chain a slight re-design. This in order to have the I/O cables guided more properly.

The old version of the drag chain. Printed in Prusa Silver PLA…
The first two pieces of the new drag chain. It now has some “chambers” in order to guide the cables in a cleaner way
My prusa i3 mk3s had to print for quite some time (23 pieces each 2 hours printing time)

1 comment

Leave a Reply

Your email address will not be published. Required fields are marked *

Author

daniel.boller@email.ch

Related Posts

In

3D-Printing: Hook system for kitchenware

Had some aluminium profile left over from my Desk-PC project. So I once again went to the drawing board and quickly designed...

Read out all
In

Cosmetical updates for my HTPC

I recently updated my HTPC. The following parts were changed:

Read out all
In

Smarthome Update: Finally a purpose for my old tablet

I had this old tablet from Aldi lying around. Initially used it was used as an ebook reader. However, I always wanted...

Read out all
In

Desk-PC 2.0 Update: Front cover finally painted

I finally managed to spray paint the cover of the left drawer. Used some aluminum primer first, then three layers of white...

Read out all
In

Desk-PC 2.0 Update: External cable management completed

I finally found a nice looking cable tube which fits perfectly into my setup.

Read out all
In

The Makeover: HTPC in the spotlight

It has been a while since I last modified my HTPC in the living room. I finally had some time and a...

Read out all