×

Desk-PC 2.0 Update: Closing the gap

In

I am currently working on closing all the open gaps and outer surfaces on the desk. Current target is to close the backside of the table. Here some pics of the as-is situation:

That ugly view needs to be hidden.
The 3D prints on the left side will be used to hold the acrylic glass cover by using magnets. The acrylic will have some very thin metal sheets glued to it.

The approach to mount the surfaces will be the same as already described this post: https://chspeedy.com/2020/06/24/desk-pc-2-0-update-gluing-the-magnetic-sheets-for-cover-installation/

Update to follow

Leave a Reply

Your email address will not be published. Required fields are marked *

Author

daniel.boller@email.ch

Related Posts

In

3D-Printing: Hook system for kitchenware

Had some aluminium profile left over from my Desk-PC project. So I once again went to the drawing board and quickly designed...

Read out all
In

Cosmetical updates for my HTPC

I recently updated my HTPC. The following parts were changed:

Read out all
In

Smarthome Update: Finally a purpose for my old tablet

I had this old tablet from Aldi lying around. Initially used it was used as an ebook reader. However, I always wanted...

Read out all
In

Desk-PC 2.0 Update: Front cover finally painted

I finally managed to spray paint the cover of the left drawer. Used some aluminum primer first, then three layers of white...

Read out all
In

Desk-PC 2.0 Update: External cable management completed

I finally found a nice looking cable tube which fits perfectly into my setup.

Read out all
In

The Makeover: HTPC in the spotlight

It has been a while since I last modified my HTPC in the living room. I finally had some time and a...

Read out all