I designed a special channel/bracket in order to install the water pumps with as less vibration as possible. I therefore used some “shoggi sandwiches”. Here some pictures of the process:
One part of the 3d printed channel 
Placing the lower part of the shoggy sandwich 
Fixing the lower part with screws 
Lower part fixed 
Top part of the sandwich applied 
This is the shoggy sandwich
Please note that I will upload pictures of the entire channel later
Author
daniel.boller@email.ch
Related Posts
3D-Printing: Hook system for kitchenware
Had some aluminium profile left over from my Desk-PC project. So I once again went to the drawing board and quickly designed...
Read out all
Cosmetical updates for my HTPC
I recently updated my HTPC. The following parts were changed:
Read out all
Smarthome Update: Finally a purpose for my old tablet
I had this old tablet from Aldi lying around. Initially used it was used as an ebook reader. However, I always wanted...
Read out all
Desk-PC 2.0 Update: Front cover finally painted
I finally managed to spray paint the cover of the left drawer. Used some aluminum primer first, then three layers of white...
Read out all
Desk-PC 2.0 Update: External cable management completed
I finally found a nice looking cable tube which fits perfectly into my setup.
Read out all
The Makeover: HTPC in the spotlight
It has been a while since I last modified my HTPC in the living room. I finally had some time and a...
Read out all