×

Cosmetical updates for my HTPC

In

I recently updated my HTPC. The following parts were changed:

  • New reservoir
  • Cleaned up tubing including flow meter
  • New custom made power cables (ATX, CPU, GPU)
  • Custom made shroud for power supply
  • 3D printed mounts for SSD’s on power supply shroud
  • one Additional SSD
  • RGB covers for SSD’s
  • RGB heatsink for m.2 drive

Leave a Reply

Your email address will not be published. Required fields are marked *

Author

daniel.boller@email.ch

Related Posts

In

3D-Printing: Hook system for kitchenware

Had some aluminium profile left over from my Desk-PC project. So I once again went to the drawing board and quickly designed...

Read out all
In

Smarthome Update: Finally a purpose for my old tablet

I had this old tablet from Aldi lying around. Initially used it was used as an ebook reader. However, I always wanted...

Read out all
In

Desk-PC 2.0 Update: Front cover finally painted

I finally managed to spray paint the cover of the left drawer. Used some aluminum primer first, then three layers of white...

Read out all
In

Desk-PC 2.0 Update: External cable management completed

I finally found a nice looking cable tube which fits perfectly into my setup.

Read out all
In

The Makeover: HTPC in the spotlight

It has been a while since I last modified my HTPC in the living room. I finally had some time and a...

Read out all
In

Desk-PC 2.0 Update: Closing the gap

I am currently working on closing all the open gaps and outer surfaces on the desk. Current target is to close the...

Read out all